Viktory use high quality and testet material for the covers.

Viktory use high quality and testet material for the covers.

page1image5832272COMPOSITION: ZUSAMMENSETZUNG:

100 % POLYESTER

page1image5833312WIDTH: 150 cm +/-2%

BREITE:

page1image1609056WEIGHT: 185 g/m2 +/-5%

GEWICHT:

TEAR STRENGTH ISO 5081

ZUGFESTIGKEIT

page1image1636096WARP 505 N

KETTE

WEFT 491 NSCHUSS

 

ELONGATION ISO 5081

AUSDEHNUNG

WARP 73,3 %

KETTE

WEFT 104,9 %SCHUSS

 

SEAM STRENGTH 6 mm / BS-3320

NAHTVERSCHIEBUNG

page1image1637968WARP > 200 N

KETTE

page1image1638592

WEFT > 200 NSCHUSS

ABRASION RESISTANCE BS-5690

SCHEUERFESTIGKEITSPRUEFUNG

> 30.000

page1image1642128

PILLING TEST ISO-DIS 12945/2 PILLING TEST

page1image16429605
page1image1643792LIGHT FASTNESS BS-1006-BO2

LICHTECHTHEIT

page1image16446245

RUBBING FASTNESS BS-EN ISO

REIBECHTHEIT 105-X12

page1image1646080

DRY 4-5

TROCKEN SUHO

page1image1646704

WET 4-5

NASS

page1image2891648

FABRIC PROTECTION: STOFFSCHUTZ: PROTEZIONE TESSUTO:

page1image2890864

WATER REPELLENT WASSERABWEISEND IDROREPELLEN

ČIŠČENJE / CLEANING / PFLEGEREINIGUNG / ČIŠĆENJE

page1image1767104page1image1766880page1image1767328page1image1767552page1image1767776

Different ignition sources are applied to a constructed test rig to examine the burning behavior of a test material.

British BS 5852 source 0, 1,5 (Cigarette, Match) and (Crib 5)

Test method

A test rig is constructed in order to simulate a chair with the fabric to be tested. This rig is subjected to different ignition sources. There are 8 types of ignition sources, each with different heat intensity. They are classified from 1 to 8, the intensity doubling compared to the preceding source. The most frequently used are ignition source 0, 1 and 5.

Test method source 0

Source 0: smoldering cigarette A cigarette is put along the crevice of the test rig and allowed to burn over its entire length. If no flaming or progressive smoldering is observed on both cover and interior material, the test is recorded as no ignition and the material passes the test.

Test method source 1

Source 1: simulated match A burner is lit, held along the crevice of the test rig for 20 seconds and then removed. If no flaming or progressive smoldering is observed on both cover and interior material, the test is recorded as no ignition and the material passes the test.

Test method source 5

Source 5: wooden crib 5 A crib is composed of wooden planks, glued together. Lint is attached to the bottom. After adding propane-diol the crib is placed on the test rig and ignited with a match. If no flaming or progressive smoldering is observed on both cover and interior material, the test is recorded as no ignition and the material passes the test.

Result

The test material passes or fails this test.

Leave a Reply

Your email address will not be published. Required fields are marked *